Pump Parts

1996-1998
Arctic/Coyote Models
a replacement gasket for the wet ends of pumps used in Arctic Spas hot tubs. It creates a watertight seal between the wet end and the pump's motor.

1997-1999
40 microfarad (uF) motor run capacitor used in two-speed pumps on specific Arctic Spas and Coyote hot tub models. It provides the necessary charge to activate the high-speed setting on the pump.

Fits the AquaFlo Flo-Master XP and XP2 pump series.
Designed for pumps rated at 4.0 horsepower.
Used on motors with either a 48 or 56 frame.
The pump seal assembly is sold separately and should also be replaced when replacing the impeller to prevent le

designed to prevent water from leaking past the impeller shaft into the pump's motor, and replacement is recommended when you notice leaks around the pump shaft or when replacing a worn or damaged impeller.

used with a 1-speed, 2.5 horsepower, 48-frame motor. The plumbing connections are 2-inch buttress threads (which measure approximately 3.1 inches outside to outside).

Connections: 2-inch male buttress threads (MBT) for both suction and discharge.
Discharge: Side discharge.
Efficiency: The XP2e series offers higher flow rates than its predecessor while consuming less energy.

Pump 2.5 HP Aquaflo High Efficiency 1 spd

operates on standard 110V household outlets. This pump provides both a high speed for massaging jets and a low speed for energy-efficient filtration.