1992-1998
Arctic/Coyote Models
The "L" shape is a specific design for Arctic Spas and helps to prevent leaks on the 2-inch heater union fittings.
Showingof 9 item(s)
is a replacement seal for the 2-inch heater union fitting. This seal is a "T" gasket creates a watertight seal to prevent leaks.
$--.--
Used to connect a heater to the plumbing. This nut comes in two halves that are fastened together with screws around the heater's flange, making it a convenient repair solution for broken or stripped heater unions.
$--.--
monitors water pressure in the heater manifold and protects the heater from damage if there is insufficient water flow. Not suitable for AWP models
$--.--
2019-Current
Swim Spas & Summit XL Models only (Pre & Post 2020)
Can replace PAK-112150 Spas Built in 2019 or earlier
monitors water pressure in the heater manifold and protects the heater from damage if there is insufficient water flow.
Swim Spas & Summit XL Models only (Pre & Post 2020)
Can replace PAK-112150 Spas Built in 2019 or earlier
monitors water pressure in the heater manifold and protects the heater from damage if there is insufficient water flow.
$--.--
connects the pressure switch to the main control board (PC board). A faulty pressure switch cable can prevent the heater from operating correctly and may cause flow-related error messages on the topside control panel.
$--.--
a 4.0 kW, 240V flow-through heater that is compatible with the Gecko IN.YE series spa packs.
$--.--
Heater 90 Degree with Cord 5.5kw Straight Discharge
$--.--
Showingof 9 item(s)