Wet Ends

this is the wet end of an Aquaflo XP2E pump used in some models from 2011 onward, including those with Epic pumps rated 2 through 5 horsepower. The wet end is the part of the pump that comes into contact with the water and contains the impeller.

This specific part is designed for the Flo-Master XP2e series of pumps and has a 2-inch threaded intake and discharge. It is intended for use with a 4.0 horsepower, 56-frame, thru-bolt motor and is suitable for either a single-speed or two-speed motor.

used with a 1-speed, 2.5 horsepower, 48-frame motor. The plumbing connections are 2-inch buttress threads (which measure approximately 3.1 inches outside to outside).

a specific AquaFlo/Gecko Flo-Master XP2e pump wet end used in some Apollo and Coyote hot tub models. 2-inch threaded intake and discharge connections

Connections: 2-inch male buttress threads (MBT) for both suction and discharge.
Discharge: Side discharge.
Efficiency: The XP2e series offers higher flow rates than its predecessor while consuming less energy.